Jamf pro single sign on error3/24/2023 ![]() In the Keep-Alive Timeout text box, specify a value in seconds between.In the Keep-Alive Interval text box, specify a value in seconds between 1 and 120.In the Description text box, type a description of the host for which you want to create an exception from SSO.Type the IP address, network address, or host range.From the Choose Type drop-down list, select Host IP, Network IP, or Host Range.The Add SSO Exception dialog box appears. ![]() For more information about SSO exceptions, see the Define SSO Exceptions section. (Optional) To add IP addresses or ranges to exclude from SSO queries, in the SSO Exceptions section, click Add.A maximum of four SSO Agents can appear in the list. (Optional) To add additional SSO Agents, repeat Steps 3–6.(Optional) In the Description text box, type a description of the SSO Agent.In the IP Address text box, type the IP address of the server on which the SSO Agent is installed.Select the Enable Single Sign-On (SSO) with Active Directory check box.Select Authentication > Single Sign-On.For instructions that apply to Fireware v12.1.1 or lower, see Enable Active Directory Single Sign-On (Fireware v12.1.1 or lower) in the WatchGuard Knowledge Base. If your Firebox has Fireware v12.1.1 or lower, the steps to enable and configure SSO are different. When you enable SSO through your BOVPN tunnels, SSO connections through the tunnel to your domain workstations can increase the bandwidth consumption of the tunnel. You can also specify the IP addresses (or ranges) to exclude from SSO queries, and enable SSO through the branch office VPN tunnels on your Firebox. For more information about SSO Agent failover, see the Failover section in this topic. You can also manually fail over to an SSO Agent. If the active SSO Agent becomes unavailable, the Firebox automatically fails over to the next SSO Agent in your configuration. In Fireware v12.2 or higher, you can specify up to four SSO Agents. When you enable and configure the settings for SSO on your Firebox, you must specify the IP address of the SSO Agent. ![]() If your device runs Fireware v11.0–v11.3.x, the Authentication Settings for Terminal Services are not available. Install the WatchGuard Active Directory SSO Exchange Monitor (Optional).Install the WatchGuard Active Directory SSO Client (Optional). ![]()
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |